Knifemaker u/MikeLeValley posted a short video on r/knives this week showing an EDC blade in 80Crv2 with a finish described plainly in the title: rust blued, with classic OD green sandblasted scales over black G10 liners. The clip drew quick compliments on the steel choice and one blunt dissenter, u/Jdaddy2u, who wrote, "Not a fan of 'rust'. But whatever makes you happy." That split reaction is the usual story whenever the word rust appears next to a finished blade, and it is worth walking through what the process actually does.

The chemistry: choosing your rust
Ordinary red rust is hematite, Fe2O3. It is porous, flaky, and holds moisture against the steel underneath, so it spreads. Black oxide, magnetite, Fe3O4, is the useful cousin: hard, stable, and adherent. Rust bluing forces the first and converts it into the second.
The sequence, documented since 19th-century gunsmiths used it on shotgun barrels and double guns, runs like this. The steel gets an acid solution applied, then sits and rusts uniformly. A bath of boiling water converts the red oxide to black magnetite, with the hydrogen in the steam doing the chemical work. While the surface is still soft, the loose oxide is carded off with a fine wire brush, historically one with wires around 0.002 inch thick. Then the cycle repeats, eight or more times in traditional work, until the color reaches the deep blue-black the maker wants. A final oiling seals it.
Gunmakers largely abandoned the method once hot caustic-salt bluing arrived, because rust bluing can take days per part. It survives in restoration work, on soldered shotgun ribs that hot salts would melt, and among hobbyists, whose modern versions often swap the dangerous acids for a hydrogen peroxide and salt solution to force the rusting step.
Why makers still bother
Two reasons keep the process alive. First, durability: because magnetite is grown from the steel's own surface rather than deposited, a rust-blued finish resists rust and wear better than cold bluing, and repeated carding leaves a depth of color that salts-and-heat finishes do not match. Second, appearance on high-carbon steel: 80Crv2, an 1080-family steel with small chromium and vanadium additions prized for toughness in fixed blades, takes the finish evenly, and the contrast against freshly ground, polished edges is sharp. As one commenter, u/cyberpunan, put it on the thread, "When you get it ground and sharp the contrast will look awesome."
"When you get it ground and sharp the contrast will look awesome."
u/cyberpunan, r/knives
The dissenter's complaint has a real basis too. A rust-blued surface is still oxide, and it still wants oil. Skip maintenance on a carbon blade finished this way and red rust will find it, same as any bare carbon steel. The finish slows the clock; it does not stop it.
For a working EDC in 80Crv2 with OD green scales, the choice reads less like nostalgia and more like a maker picking a finish that will look right after years of hard use, scratches and all.
"80CRV2/1080+ is good stuff," the same commenter added, noting makers like Tony Mont run similar finishes. "It is cool."