DM1(Camillus) - High carbon, low alloys steel. Used by A.G. Russel exclusively. The DM1 steel was developed by Dan Margini, specifically for A.G. Russel, as well as the heat treat protocol for it. Optimized for toughness in large, hard use knives. It is a successor of the 0170-6 steel which was used by Cold Steel under Carbon V name, Blackjack knives, etc.
Composition
Core alloying elements define the baseline trade-off between wear resistance, corrosion behavior, and toughness.
| Element | Content | Primary Role |
|---|---|---|
| CCarbon | 0.950% | Carbon — the core element for hardness and edge keenness |
| CRChromium | 0.450% | Chromium — provides stainless properties and corrosion resistance |
| MNManganese | 0.460% | Manganese — deoxidizer that also aids strength |
| VVanadium | 0.190% | Vanadium — forms hard carbides that raise wear resistance and strength |
Material Overview
Performance Radar
Use four core metrics to understand the usable operating envelope of this steel at a glance.
Edge Retention
Toughness
Corrosion Resistance
Sharpenability
Edge Retention
6.0
Toughness
8.0
Corrosion Resistance
2.0
Sharpenability
9.0
Similar Steels Comparison
Compare core performance dimensions against steels of the same type, powered by the steel database ratings.
| Steel | Hardness | Overall Score | Edge Retention | Toughness | Corrosion Resistance | Sharpenability |
|---|---|---|---|---|---|---|
| 0170-6C Latrobe Specialty Steel (historically) | 57–60 HRC | 7.5 | 6.0 | 8.0 | 2.0 | 9.0 |
| MagnaCut Crucible Industries | 60–64 HRC | 10.0 | 9.0 | 10.0 | 10.0 | 8.0 |
| CPM-MagnaCut Crucible Industries | 60–64 HRC | 10.0 | 9.0 | 10.0 | 10.0 | 8.0 |
| CPM MagnaCut Crucible Industries | 60–64 HRC | 10.0 | 9.0 | 10.0 | 10.0 | 8.0 |
Frequently Asked Questions
What is the typical hardness of DM1?
DM1 typically runs around 58–59 HRC (HRC, Rockwell hardness). Actual blades may vary slightly depending on the heat treatment and batch.
How rust-resistant is DM1?
The steel database rates its corrosion resistance at 2.0/10 — the higher the score, the better it resists rust in humid or corrosive environments.
How tough is DM1? Does it chip easily?
The steel database rates its toughness at 8.0/10 — the higher the score, the better it handles hard use, prying and cutting abrasive materials.